Darning and Embroidery Foot
Raise needle to highest position by turning hand wheel
toward you. Raise foot. Loosen presser foot screw and
remove presser foot shank: Guide Darning and Embreid_
ery Foot into position from back of machine. Make sure
lifting finger is above needle ctamp. Tighten presser foot
screw with coin.
/
_er
CHANGING PLATES
Note: Remove bobbin if it contains thread in order to
prevent thread being caught when plate is replaced.
Raise take-up lever to its highest position by turning
the hand wheel toward you. Raise presser fQot, Pull
slide plate toward you, As shown in top diagram at
_ight, press down on front edge of plate you have been
sewing with, and lift up and out.
Position new plate over pins. Ptate is d_awn into posi-
tion by magnets. Replace bobbin. Close slide plate.
Attaching Darning and Embroidery Foot
CHAINSTITCH PLATE AND iNSERT
Raise take-up lever to its highest position and raise
presser foot, Open slide plate, Move bobbin latch to
left and remove bobbin and plate you have been sew-
ing with. Place bobbin*case insert in bobbin case as
shown, with finger of insert positioned under the feed.
Position chainstitch plate over holding pins, making
certain that the post of the bobbin-case insert finger
enters the hole in the plate. Close slide plate.
To Next Page
Loading...
