Replacing a Wound Bobbin
Raise take-up lever. Open stide plate move latch to eft
Draw four inches of thread from bobbin and mace DODDIR
in case. Pull thread into slo_ of bobbin case at Point 1
araw it under flat senng and beyond Point 2. Leave four
inches of free thread. Leave suae Dlate open
Raising the Bobbin Thread
] MOle neea e tnreaa ilgntl'_ with left qand and turn
nanc Nheel slo_ , toward you so needle en[ers
elate.
2. Continue um neeule rises. Tigmen no_o on neee_e
tnreaa anc erlrg ue _ooe of bobbin thread.
3. Oeen IOODwith fingers and pUll needle ane DODDIn
threads under presser foot elag3nally ;o me eft
Close slide dlate
Replacing a Wound Bobbin
Insert Bobbin
Pull Thread into
Slot at Point 1
Flat Spring,,
Removing Thread from Bobbin
You can leave the bobbin in place while removing
thread. With slide plate closed, pull thread end toward
you thrdugh plate with a steady motion. Do not pull
thread across feed as this may damage feed.
Draw Thread
Under Fiat Spring
Beyond Point 2
To Next Page
Loading...
