20
27 & 28
Bias Gauge
The Bias Gauge will be found very useful (especially in the case of soft materials) when cut-
ting bias steps from 7/16 inch to 1 3/8 inches in width. This may be done by placing the bias
gauge upon the point of the scissors and setting the blued indicator to the width desired. The
line F is the point at which to set the blued indicator for facings, the line B for binding, and the
line C for cording or piping.
Insert the material in the gauge with the edge against the blued indicator, and hold as shown
above.
Bias binding for use with the Binder Attachment should be cut 15/16 inch wide, and to do this
the indicator should be set midway between the lines F and B.
To Next Page
Loading...
