Singer NO. 27 - Winding the Bobbin

9
27 & 28
To Wind the Bobbin
(See Fig. 6)
Loosen the hand wheel (see Fig. 3) and push
the top of the winder from you until its rubber
ring (5) just touches the ledge of the hand
wheel. Turn the latter over towards you until
the thread guide (2) moves to the extreme
right. Place a reel of thread on the spool pin;
and pass the end of thread through the notch
at top of the face plate (13, Fig. 5); then
thread the winder by passing the thread
upward through the eyelet (1) and into the
notch (2). Draw the knob (3) to the left, and
place an empty bobbin between the cup at
the right (4) and the centre hole at the left.
Now clamp the end of thread between the
cup and the end of the bobbin, turn the hand
wheel towards you and wind by operating the
machine as when sewing. When nearly full
remove the bobbin by pulling the knob (3) to
the left, then withdraw the winder from the
ledge of the hand wheel and tighten the latter
by turning the stop motion screw from you.
FIG. 6