PRE-OPERATION FUNCTION TEST
GTZZ18J Operation Manual 6-15 © Oct. 2022
TIPPING HAZARD
While performing override operation on
the machine, please avoid operation in
a dangerous direction.
For overseas models, with the machine in the KG
mode, if activating any function switch while flipping the
emergency power switch after an overload alarm, the
override operation should be performed, and the
corresponding action can be performed. The time of the
override operation and the actual weight on the
platform are recorded on the display.
NOTICE
Override operation is an emergency operation in an
emergency state. Before conducting any override
operation, please make sure the surrounding area
and the whole machine are in a safe state, try to
avoid operation in a dangerous direction and ensure
personal safety.
CONNECTOR
REPOSITIONING
In normal conditions, the connector should always
remain perpendicular to the turntable, but due to the
leakage of the connector leveling cylinder, the
connector may tilt after a long period of use. When
operating the machine, please pay attention to the
status of the connector. If the connector is tilted, please
stop using the machine immediately and reposition the
connector to restore the connector to its normal state.
Figure 6-5 Connector perpendicular to the turntable
The connector may be tilted in two directions: backward
tilt and forward tilt.
Connector tilted backward
To Next Page
Loading...
