© Mar. 2022 3-12 GTTZ10EJ Operation Manual
SAFETY
WELDING HAZARDS
• Comply with the welder manufac-
turer’s recommendations for pro-
cedures concerning proper use of
the welder.
• Welding leads or cables may only
be connected after turning off the
power unit.
• Carry out welding operations only
after the welding cable has been
correctly connected.
• Do not use the machine as a
ground wire during welding
operation.
• At all times, make sure that the
power tools are completely stored
in the working platform. Do not
hang the power tools on the rail-
ing of the working platform or the
work area outside the working
platform, or hang the power tools
directly by the wire.
Before performing welding, grinding and polishing work,
welders must seek permission of the responsible de-
partment at the workplace.
LOCKOUT AFTER EACH
USE
1. Choose a safe parking location that is on sturdy,
level ground and that is free of obstructions and
heavy traffic.
2. Lower the mast to stowed position.
3. Push in the emergency stop button at ground
controls to the OFF position.
4. Push in the emergency stop button at platform
controls to the OFF position.
5. Turn the key switch at the ground controls to OFF
position and remove the key to avoid unauthorized
operation of the machine.
6. Turn off the power disconnect switch.
7. Charge the battery.
NOTICE
After using the machine, the power disconnect switch
must be turned off.
To Next Page
Loading...
