© Jun 2022 3-12 TB24 Plus&26J Plus Operation Manual
SAFETY
HYDRAULIC HAZARDS
BURN AND SPRAY HAZARDS
• When the hydraulic system is hot,
do not touch to avoid severe skin
burn.
• After the machine shutdown,
thoroughly clean the spilled
hydraulic oil. Do not throw the oil
on the ground. Once the
maintenance and repair is
complete, immediately clean any
oil on the skin, Dispose of the
used oil as per the governing laws
and regulations.
• Do not use your hand to block the
hydraulic leaks. If the leakage
occurs, please first release the
system pressure and maintain
only after the hydraulic oil cools
down. If any injury is caused by
the spray of hydraulic oil, go to
the doctor immediately, otherwise
severe complication may develop.
WELDING AND POLISHING
REQUIREMENTS
Before welding, grinding and polishing operations,
always ensure you read and understand all operation
and maintenance requirements in the Operation
Manual and the Maintenance Manual.
WELDING HAZARDS
• Comply with the welder
manufacturer’s recommendations
for procedures concerning proper
use of the welder.
• Welding leads or cables may only
be connected after turning off the
power unit.
• Carry out welding operations only
after the welding cable has been
correctly connected.
• Do not use the machine as a
ground wire during welding
operation.
• At all times, make sure that the
power tools are completely stored
in the working platform. Do not
hang the power tools on the
railing of the working platform or
the work area outside the working
platform, or hang the power tools
directly by the wire.
Before performing welding, grinding and polishing work,
welders must seek permission of the responsible
department at the workplace.
AFTER USING THE
MACHINE
1. Choose a safe parking location that is on sturdy,
level ground and that is free of obstructions. Avoid
areas with heavy traffic.
2. Lower the boom to stowed position.
3. Take off all loads from the platform and run the
enghine at low speed for 3–5 minutes to reduce the
engine inside temperature.
4. Push in the emergency stop button at the platform
controls to the OFF position.
5. Close the cover of platform controls to protect the
control panel,handle and controller from hostile
weather conditions.
6. Push in the emergency stop button at ground
controls to the OFF position.
7. Turn the key switch at the ground controls to OFF
position and remove the key to avoid unauthorized
operation of the machine.
8. Turn off the main power switch.
To Next Page
Loading...
