Need help?Do you have a question about the SINTERIT LISA and is the answer not in the manual?
General| Technology | Selective Laser Sintering (SLS) |
|---|---|
| Build Volume | 150 x 200 x 150 mm |
| Laser Type | Diode Laser |
| Laser Power | 5 W |
| Nitrogen Chamber | Yes |
| Software | Sinterit Studio |
| Layer Thickness | 0.075 - 0.175 mm |
| Supported Materials | PA12, PA11, TPE, TPU |
| Connectivity | Wi-Fi, USB |
| Print Speed | Up to 14 mm/h (depending on material and geometry) |
| Power Requirements | 230V, 50/60Hz, 16A |
| Scanning Speed | Up to 2 m/s |
To Next Page
