SINTERIT LISA - Contents of the Sinterit Lisa Pack

Sinterit Lisa printer SHORTENED USER GUIDE | 13
Image 39. The OVERFLOW BIN cleaning screen. Image 40. Correct cleaning of the OVERFLOW BIN.
13. Next, the information about refreshing the
remaining unsintered powder will appear.
• The quantity of Fresh Powder (for PA12 and
PA11) needed to be added for the next print
will be displayed on the screen (Image 41).
• This information is also available in the Sinterit
STUDIO report after preparing the le for
printing (SLICE tab).
14. Next steps will guide you through the printer
cleaning process. It allows recovering all of the
remaining unsintered powder.
Add 0.9 litres of fresh powder to the
powder removed from the printer
FileName_01.scode
DONE
Image 41. Screen with information about how much of Fresh
Powder needs to be added for the next print.
IMPORTANT!
• Always pay attention to the messages displayed on the LCD screen. Not acting according
to the messages may result in the following print being incorrect.
• The Sinterit STUDIO software also calculates the amount of Fresh Powder, which needs to
be added to that recovered from the printer.
• Even if you do not intend to make the following print right after the previous one, mix
both powders immediately after recovering the unsintered powder from the printer in
the proportions given by the Sinterit STUDIO software. Store it in a container for the Print
Ready Powder.
6. Cleaning the printer
The system will guide you through the process of cleaning the printer right after printing. You can also do it later,
by using the CLEAN PRINTER option displayed in the main menu. All actions should be conrmed by pressing the
”DONE” button.
1. Remove and clean the LASER PROTECTIVE GLASS
(Image 42). It is recommended to clean the glass
before and after each print. To clean the glass, follow
the instructions from section 2A in this manual
(“Installing/cleaning the LASER PROTECTIVE GLASS”).
2. Place the glass back in its place and then conrm all
actions by pressing the ”DONE” button.
Remove and
clean the laser
protective glass,
Image 42. LASER PROTECTIVE GLASS cleaning screen.