6
SAFETY INSTRUCTIONS….cont
designed.
DO NOT OPERATE THE INVERTER WELDER IN EXPLOSIVE ATMOSPHERES: Do not use the
inverter welder in the presence of flammable liquids, gases, dust or other combustible
sources. Inverter welding will create sparks which can ignite the dust or fumes.
DO NOT EXPOSE THE INVERTER WELDER TO RAIN OR USE IT IN WET CONDITIONS: Water
entering the inverter welder will greatly increase the risk of electric shock.
HAVE YOUR INVERTER WELDER REPAIRED BY A QUALIFIED PERSON: The inverter welder is
in accordance with the relevant safety requirements. Repairs should only be carried
out by qualified persons using original spare parts, otherwise this may result in consid-
erable danger to the user.
Stop operation immediately if you notice anything abnormal.
Always disconnect the plug from the mains supply before cleaning or servicing
etc.
Be alert at all times, especially during repetitive, monotonous operations; Don't
be lulled into a false sense of security.
Use of improper accessories may cause damage to the inverter welder and
surrounding area as well as increasing the risk of injury.
Do not modify the inverter welder to do tasks other than those intended.
To avoid injury, the workpiece should never be held with bare hands; The work-
piece will become hot during normal welding operations, and stay hot for a
period after the weld is complete.
Appropriate personal protective equipment must be worn and must be de-
signed to protect against all hazards created. Severe permanent injury can re-
sult from using inappropriate or insufficient protective equipment - Eyes in par-
ticular are at risk.
The work should be clamped firmly whilst welding, If its loose it could result in
personal injury or damage to the machine or item that is being welded.
Do not attempt any repairs unless you are a competent electrician or engineer.
Ensure that the machine is connected to the correct supply voltage and pro-
tected by a fuse or circuit breaker of the recommend rating.
Never allow the earth clamp and electrode holder to come into contact with
each other.
To Next Page
Loading...
Need help?
General
