Sirona C8+ - Accessories

3 Electromagnetic compatibility Sirona Dental Systems GmbH
Installation Requirements C8
+
60 28 000 D3417
50 D3417.021.04.09.02
båÖäáëÜ
•The UNIT may be operated only with accessories and
spare parts approved by Sirona. Unapproved accesso-
ries and spare parts may lead to an increased emission
of or a reduced immunity to interference.
•The UNIT should not be operated immediately adjacent
to other devices. If this proves to be unavoidable, the
UNIT should be monitored to check and make sure that
it is used properly.
The EMC measurements were performed with the following
PCs:
3.1 Accessories
Making the PC connection
Designation of interface cables
for the PCs
Supplier
XGA cable, 10m (L38) Sirona
S video cable, 10m (L15) Sirona
RS232 cable, 10m (L37) Sirona
Audio cable, 10m Sirona
FireWire, 10m
(for the CEREC-PC)
Sirona
2nd protective ground wire, 2.5mm
2
, 10m Siron a
PC as peripheral device for
checking the interfaces
with:
PC 1: Siemens Fujitsu,
Pentium III, 650 MHz
PC 2: Siemens Fujitsu,
Pentium IV, 2,4 GHz
Extension of the PCs
Graphics card PC 1/2: Graphik - Controller
Matrox Millenium G450
DualHead
PC 3: Graphik controller
MS I NX 6800GT
Frame grabber card PC 1: PicPort Color frame
grabber card (Leutron)
REF: 46 93 961