Sirona Cerec - Transitions between States

65 45 177 D3492
D3492.201.09.01.02 05.2015
23
Sirona Dental Systems GmbH 6Networking
Operating Instructions CEREC Radio Device 6.6Network unit states
båÖäáëÜ
6.6.2 Transitions between states
The transitions between these states are given in the following figure:
These transitions are described in the table below:
,QLWLDOVWDWH
%RRWLQJ
1HWZRUNLQJ
6HSDUDWHG
&RQQHFWHG
7UDQVIHU
,VRODWHG
(UURU
1RRWKHUGHYLFHVIRXQG
DQ\
State Next state Description
Initial state Booting The booting program starts after a restart or after switch-on.
Booting Networking A network setup timer of one minute is started. During this time, other
network units are searched for. When the other units are also in the
networking state, they become part of the same network.
Networking Isolated No other network units were found within one minute.
Networking Separated The network unit starts searching for other network units of the same
network.
Separated Connected At least one other network unit was found in the same network.