QuickCollect CMDT 391 / CMDT 391-Ex 4 - 7
User Manual – Revision B
Taking Measurements
To connect to a sensor and obtain measurement data:
IMPORTANT! The phone’s Bluetooth function must be on to communicate with a
QuickCollect sensor.
Navigate to the Devices table by tapping Connect to a sensor in the middle of the
home screen or the devices icon in the top left of the screen.
Figure 4 – 7.
Navigating to the Devices table from the home screen.
The names of the available QuickCollect sensors will appear in the Devices table with
their signal strengths indicated to the right.
• Tap to select the desired sensor.
➢ If the deies Bluetooth feature is ot o, there will be a prompt to
turn it on. Tap Settings to navigate to the deies Settigs area and
enable Bluetooth.
To Next Page
Loading...
