SKF MAX-1-2-115-IF105-R-V2 - Maxilube with STA lid set

51 pages

Save Page as PDF

To Next Page

To Previous Page

18. When you have completed these actions, you can fill/bleed the manifold/branch piping.

Main Page

Masthead5
Table of Contents6
Safety Alerts, Visual Presentation, and Layout8
Safety Instructions9
General Safety Instructions9
General Electrical Safety Instructions9
General Behaviour When Handling the Product9
Intended Use9
Persons Authorized to Use the Product10
Foreseeable Misuse10
Referenced Documents10
Prohibition of Certain Activities10
Painting Plastic Components and Seals10
Safety Markings on the Product10
Notes on the Type Plate11
Note on Low Voltage Directive11
Note on Pressure Equipment Directive11
Notes Related to the TüV Approval Mark11
Notes on CE Marking11
Notes Related to the UKCA Marking12
Note on EAC Marking12
Note on China Rohs Mark12
Emergency Shutdown12
Assembly, Maintenance, Fault, Repair12
First Start-Up, Daily Start-Up12
Residual Risks13
Lubricants14
General Information14
Material Compatibility14
Temperature Properties14
Aging of Lubricants14
Avoidance of Faults and Hazards14
Solid Lubricants15
General Description16
Maxilube Pumping Centre16
SKF Maxilube Changeover Valve Unit17
Operation18
Operation of the Pumping Centre18
Commissioning18
Connections19
Commissioning with Maxilube Ecolid Set and MPB Pump20
Commissioning with Maxilube Stalid Set and MPB Pump22
Replacing the Lubricant Barrel23
Maxilube ECO with Lid Set and MPB Pump23
Maxilube STA with Lid Set and MPB Pump24
Manual Operation25
IF-105 User Interface26
General Description26
Main Components26
Channel Leds27
Function Leds27
Buttons28
Display28
Operation of IF-10529
Normal Mode29
Phase Codes for Normal Mode and Alarm Mode30
Normal Mode Displays, Single and Dual Line Lubrication Systems31
Normal Mode Displays, Progressive Lubrication System32
Pressure and Pulse Displays for Lines33
Power Failure33
Alarms33
Manual Operation35
IF-105 Settings35
IF-105 Technical Specifications37
Legend37
Modbus RTU Fieldbus Interface38
Features38
Parameters38
Connections39
Modbus Registers40
Settings41
Commands42
Maxilube Troubleshooting Table43
Maxilube Technical Specification45
Technical Specification Maxilube Changeover Valve Unit45
Symbols Maxilube Changeover Valve Unit46
Order Codes, SKF Maxilube Changeover Valve Unit47
Maintenance48
Cleaning48
Basics48
Interior Cleaning48
Exterior Cleaning48
Periodic Inspections48
Decommissioning and Storage49
Temporary Shutdown49
Final Decommissioning49
Storage49
Spare Parts50
Appendix51
China Rohs Table51

SKF MAX-1-2-115-IF105-R-V2 - Maxilube with STA lid set

Table of Contents

Other manuals for SKF MAX-1-2-115-IF105-R-V2

Related product manuals