EasyManua.ls Logo

Ski-Doo REV GEN4 - MAINTENANCE PROCEDURES

Ski-Doo REV GEN4
323 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
MAINTENANCE SCHEDULE
EVERY YEAR AT PRESEASON OR 3 000 KM (2,000 MI)
(WHICHEVER COMES FIRST)
Perform pre-ride inspection
Check fault codes
Charge battery
Adjust drive chain
Inspect track te nsion, adjust and align (if necessary)
Inspect brake hose, pads and disk
Check coolant density
Inspect drive belt
Inspect and clean drive pulley
Tighten drive pulley retaining screw to specified torque
Inspect and clean driven pu lley
Inspect engine seals and gaskets for leaks
Lubricate rear suspension. Lubri cate whenever the vehicle is
used in wet conditions (rain, puddles)
Inspect exhaust system and check for leaks
Tighten exhau st manifold screws to specified torque
Inspect fuel lines and connections
Inspect front suspension
Inspect rear suspension (including stopper straps and slider
shoes)
Inspect tie-rod ends and ski alignment
Adjust headlight beam aiming
_________________
207

Table of Contents