MAINTENANCE PROCEDURES
Track
Track Condition
WARNING
Remove tether cord cap from engine cut-off switch before
performing any maintenance or adjustment, unless otherwise
specified. Vehicle must be parked in a safe place, away from
the trail.
Remove tether cord cap from engine cut-off switch.
Lift the rear of the snowmob ile and support it with a wide-base snow-
mobile mechanical stand with a rear deflector p anel. With the engine
off, rotate the track by hand, and inspect condition. If worn or cut, or
if track fibers are e xposed, or if missing or defective inserts or guides
are noted; contact an authorized Ski-Doo dealer.
Snowmobiles Equipped with Traction Enhancing Products
If your snowmobile is equipped with a BRP approved studded track,
PROCEED W ITH A VISUAL INSPECTION OF YOUR TRACK BEFORE
EACH USE.
Look for any defects, such as:
– Perforations in the track
– Tears in the track (particularly aro und traction holes on studded
tracks)
– Lugs that are broken or torn off, exposing portions of rods
– Delamination of the rubber
– Broken rods
– Broken studs (studded tracks)
– Bent studs (studded tracks)
– Missing studs
– Studs that are torn off the track
– Missing track guide(s)
– Also, ensure that stud nuts are tighten to the recomm ended tight-
ening torque.
On approved studded tracks, replace broken or damaged studs im-
mediately. If your track shows signs of deterioration, it must be re-
placed immediately. When in doubt, ask your dealer.
230
_________________
To Next Page
Loading...
