RIDING THE VEHICLE
4. Check fuel and oil levels and look for leaks. Replenish if neces-
sary and in case of any leaks; you should seek service from an
authorized Ski-Doo dealer, repair shop, or person of your own
choosing for maintenance, repair, o r replacement. Please refer
to the
US EPA EMISSION-RELATED WARRANTY
contained
herein for information about warranty claims.
5. All storage compartments must be properly latched and they
must not contain any heavy or breakable objects. Hood and side
panels must be also properly latched.
6. Activate the throttle control lever several times to check that it op-
erates easily an d smoothly. It must return to idle position when
released.
7. Activate the brake lever and make sure the brake fully applies be-
fore the brake control lever touches the handlebar grip. It must
fully return when released.
8. Apply parking brake and check if it operates properly. Leave park-
ing brake applied.
9. Inspe ct drive belt condition and height, refer to
DRIVE BELT
in
MAINTENANCE PROCEDURES
.
After Engine is Started
For proper engine starting procedure, refer to
ENGINE STARTING
PROCEDURE
.
1. Check headlights high beam and low beam, taillight, stop light
and pilot lamps operation.
NOTE: You may need to detach tether cord from your clothes to
check lights. In such a case, attach cord as soon as you get back at
the controls of the snowmobile.
2. Check the engine cut-off switch (by pu lling tether cord cap) and
emergency engine stop switch operation.
3. Release parking brake.
4. Refer to
VEHICLE WARM UP
and follow instructions.
____
SAFETY INFORMATION
___
21
To Next Page
Loading...
