WARNING
– Never stud a track that has not been approved for studs.
Approved tracks can be identified by a stud symbol (see
illustration) molded into the track surface.
– Studs should only be installed in the locations indicated by
molded bulges in the track surface.
– Never stud a track with a profile of 35 mm (1.375 in) or
more.
– The number of studs installed must always perfectly match
the pattern of molded bulges in the track.
– Always consult the traction product manufacturer’sinstal-
lation instructions and recommendations before having
your dealer install studs and runners. It is very important
to follow the torque specifications for the stud bolts.
INSTALLING AN INCORRECT NUMBER OF STUDS OR AN IM-
PROPER INSTALLATION CAN INCREASE THE RISK OF THE
TRACK TEARING OR SEVERING, POSSIBLY RESULTING IN SE-
RIOUS INJURY OR DEATH.
A33A35A
APPROVED TRACKS CAN BE IDENTIFIED BY THIS SYMBOL
Maintenance/Replacement
PROCEED WITH A VISUAL INSPECTION OF YOUR TRACK BEFORE
EACH USE.
Look for any defects, such as:
– perforations in the track
– tears in the track (particularly around traction holes)
– lugs that are broken or torn off, exposing portions of rods
– delamination of the rubber
_____
SAFETY INFORMATION
_____
35
To Next Page
Loading...
Need help?
General
