19
ASSEMBLY
Tools Needed For Assembly And Alignment
WARNING
Disconnect plug from power source before performing any assembly,
adjustment or repair to avoid possible injury.
12 mm / 1/2” Wrench
or Adjustable Wrench
Hex “L” Wrench
(supplied) 5mm
#3 Phillips Screwdriver
Combination Square
Combination Square Must be True
Draw Light Line on Board
Along this Edge
Straight Edge of Board
3/4” Thick
.
This Edge Must
be Perfectly Straight
Should be no Gap or Overlap
when Square is Flipped Over
in Dotted Position
To Next Page
Loading...
