Description
Fig. 139 Carrier for the towing device/tow bar
Read and observe
and on page 153 first.
The ball rod can be removed and can be found in the spare wheel well or in a
compartment for the spare wheel in the boot » page 192.
Support for the towing device/tow bar » Fig. 139
13-pin power socket
Mounting recess
Safety eyelet
Cover for the mounting recess
Dust cap
Locking ball
Green marking on the handwheel
Handwheel
Key
Lock cap
Red marking on the handwheel
Green box on the tow bar
Tow ball
Note
On the bottom of the key is a code number. If you lose a key, please contact a
specialist garage, who will be able to use this code number to provide you with
a new one.
1
2
3
4
5
6
7
8
9
10
11
12
13
Adjusting the ready position
Fig. 140 Setting the ready position
Fig. 141 Ready position
Read and observe and on page 153 first.
Always set the ready position before fitting the tow bar.
›
Turn the key
A
in direction of the arrow
1
to the stop » Fig. 140.
›
Pull the handwheel
B
in the direction of the arrow
2
and drag in the direc-
tion of the arrow
3
to the stop.
The handwheel remains locked in this position.
Correctly adjusted standby position » Fig. 141
The key
C
is in the unlocked position and cannot be removed.
The locking balls
D
can be pushed fully into the tow bar.
154
Driving
To Next Page
Loading...
