Skoda Bolero User Manual

Function problems
If problems occur with the Apple CarPlay connection, then one of the following
messages may occur in the display.
Message Meaning
… Unable to connect to mobile device. … is already connected via Apple Car-
Play.
The device allows only one active connection.
SmartLink: ... has been disconnected. Check the connection to the USB input.
Unable to connect. … is not supported by the mobile device. The connection type is not supported by the connected device.
Please note that this UBS port may not support Apple CarPlay. Use a different
USB port and try again.
The Apple CarPlay connection is not supported by the USB input. Connect the
external device to a different USB port.
MirrorLink
 Introduction
This chapter contains information on the following subjects:
Home menu
44
Operation 45
Function problems 46
The MirrorLink
™
connection can be set up under the following conditions.
The ignition is switched on.
The unit is switched on.
The device to be connected is switched on.
Some applications require that the data connection in the connected device is
turned on.
If you want to use the device menu Telephone, then before establishing the
MirrorLink
™
connection with the device then connect the device first via Blue-
tooth
®
.
A device connected using MirrorLink
™
cannot be used as an audio source in the
menu Media.
If route guidance is active at this moment in the device, then this is not termi-
nated by starting the route guidance in the MirrorLink
™
application.



The list of available applications and devices, which support the MirrorLink
™
function, can be seed in the ŠKODA Internet pages www.infotainment.skoda-
auto.com.
Home menu
Fig. 29
MirrorLink ™: Main menu
Connection set-up
The device saves the last 10 connected devices.
›
Connect the device to the USB input » Vehicle operating instructions.
›
Press the button

→ MirrorLink™.
In the main menu the MirrorLink
™
connection is shown » Fig. 29.
During the first connection set-up proceed as follows.
›
Connect the device to the USB input.
›
Press the button

→ MirrorLink™.
›
Press the function key in the displayed main menu SmartLink

.

44
Connectivity

Skoda Bolero Specifications

General

Touchscreen	Yes
Navigation	Optional
Bluetooth	Yes
USB	Yes
SD Card	Yes
Apple CarPlay	Yes
Android Auto	Yes
CD Player	No
Radio	Yes
AUX Input	Yes
SmartLink	Yes
DAB Radio	Optional
Voice Control	Yes
Steering Wheel Controls	Yes
Power Output	Varies depending on the model