Skoda OCTAVIA MK1 - Inspect the Vacuum System

G

9%$;;< E> 9%%> &
!@$97 ;!:;9!9>%
;! <%$%% !%: ! 
7% @7
>9$9%7 & !  $$;:> 
9>  @!!C
G

9$%%<%%> &
$9% %7)+7I:> =%
$  &% !!D 9%:>$!!%'
$9$%%&%$;% D 9%:F
G
!:$%$;;!> %!
D 9%:
G
!:$%$;;!> : :
$ $ %9!!%&$ ;'
G
9$! 9 :%  >$9% 
$9%!I:%!9>%<'
9%&F


!:$9%$;;!'!
Special tools and workshop equipment required
t Remote control, e.°g -V.A.G 1348/3 A- with adapter cable, e.g -V.A.G 1348/3-2-
t Hand vacuum pump, e.°g.° -V.A.G 1390 -
t Measuring tool set, e.g. -V.A.G 1594 A-
– Leave engine running at idling speed for 2 to 3 minutes (build up vacuum).
– Switch off ignition.
– Disconnect plug from valve for variable intake manifold changeover.
–
Connect one contact of the valve°with the connection line and alligator clip from -V.A.G 1594 A- to the
engine mass.
–
Lay a second contact of the valve with remote
control - V.A.G 1348/3A-, adapter cable
-V.A.G 1348/3-2- and connection line to
positive terminal.
–
Activate the remote control -V.A.G 1348/3A-
for 2 to 3 minutes. During this period, the
vacuum unit must be connected.
If the vacuum unit does not return to its initial
position, check the vacuum unit as follows:
–
Remove the vacuum lines from the vacuum
unit for intake manifold changeover.
– Connect hand vacuum pump to vacuum unit.
–
Actuate the hand vacuum pump and observe
the switch over procedure.
–
Check vacuum unit for tightness. (The vacuum
unit must not return to its initial position as
long as it is not ventilated at the hand vacuum
pump).
"0