–
Cut off nozzle tube of the silicone sealant
-D 176 404 A2 - at the front marking (Ø of
nozzle approx. 3 mm).
t Thickness of sealant bead: 2 to 3 mm
t
The sealant must be run past on the inside in the
area of the bolt holes -arrows-.
Note
The sealant bead must not be thicker than 3 mm
otherwise excess sealant may get into the oil pan
and clogg the strainer in the oil suction pipe.
–
Apply silicone sealant to the clean sealing
surface of the oil pan, as shown in the
illustration.
Note
Take particular care when applying sealant bead
in the area of the sealing flange at the rear
-arrows-.
–
Fit on oil pan immediately and tighten the bolts
as follows:
1. Tighten all the bolts of oil pan/cylinder block
slightly diagonally across.
2. Tighten the three bolts of oil pan/cylinder
block slightly.
3. Tighten all the bolts of oil pan/cylinder block
slightly diagonally across.
4. Tighten the three bolts of oil pan/gearbox to
45 Nm.
5. Tighten all the bolts of oil pan/cylinder block
diagonally across to 15 Nm.
Note
t
When installing the oil pan with the engine
removed, ensure that the oil pan is flush with
the cylinder block at the flywheel side.
t
After installing the oil pan, allow the sealant to
dry for about 30 minutes. Only then may
engine oil be filled in.
! :!!;%& :!!;!@$9
:$% !%&@ !9 :A;:A;&
:!!;!&$I7-0"7F
42
To Next Page
Loading...
