–
Remove noise insulation panel in middle as
well as on left and right -arrows-.
– Drain engine oil.
– Unbolt oil pan.
Note
Slacken oil pan bolts at flywheel side with hinged
wrench -3185- and unscrew with wrench socket
-3249-.
–
Remove oil pan, if necessary release by
applying slight blows with a rubber-headed
hammer.
–
Use a flat scraper to remove sealant residues on
the cylinder block.
–
Use a rotating plastic brush to remove sealant
residues on the oil pan (wear protective
goggles).
–
Clean sealing surfaces, they must be free of oil
and grease.
Install
Note
t
The oil pan must be installed within 5 minutes
after applying the silicone sealant.
t
Use socket insert - 3249- to insert the oil pan
bolts at flywheel side and tighten with hinged
wrench -3185 -.
t
The assistance of a second mechanic is required
to install the oil pan.
54
To Next Page
Loading...
