Skoda OCTAVIA MK1 - Page 44

–
Put the counterholder -MP 1-221- into the bore
hole on the cylinder block and screw onto the
pressure plate.
– Release screws for pressure plate.
Note
Replace screws for pressure plate.
–
Tighten bolts to 60 Nm and torque a further
90°
1
/
4
turn.
, %&!%&:%
:$% !%&@ !9 :A;:A;&
  A;@$9+ +2)I7-007F
  A;@$92 "22)I7-00"7F
  ;9 &> $;$9717""7
 :9%;
, 
 
G

%$9$ ;9 &717""7@9
5E+<  9&:%1%$@ 
2;!<@9$ ;9 &%&
9&&!$77
G ,%!!$@!> &&!$
!%
G
, 9&%:%
D $9 


