Selector key NAV (Navigation) 49
Note
During destination guidance, the travel and arrival time information always relates
to the arrival at the final travel destination. The estimated travel or arrival time at a
stopover destination is not displayed.
Enter a stopover destination
If, in addition to the displayed travel destination, travel to the destination
or several destinations still has to be undertaken, proceed as follows. You
can insert the additional destination behind the displayed travel destina-
tion as a new end point of the tour.
– After selecting a travel destination, press on the function key in
the main menu Navigation. A pop-up window will open.
– If you press , the menu New destination
will open for selecting a stopover destination. The background of the
unit changes automatically to the tour mode.
– Select a stopover destination as described ⇒ page 42.
– If you have confirmed the new destination, you will be asked to select
an entry behind which the new destination should be placed. You
therefore determine the order of the destinations. Press to close
the message.
– The main menu Navigation will now be opened in the tour mode
⇒ page 48, fig. 19.
– Press the function key to start the route guidance to the first
stopover destination of the displayed tour.
– Press the function key and then to add further desti-
nations to your tour ⇒ page 49, “Arranging a new tour in tour
mode”.
Exiting the tour mode
Ensure that all stopover destinations are deleted before you finish with
the tour mode. You can store the displayed tour with all the stopover
destinations before ending it by pressing ⇒ page 50.
– Press on the function key in the main menu Navigation and on
in the pop-up window, to end the tour mode.
– Confirm the message “Would you like to exit the tour mode?” by
pressing the function key .
– Only the travel destination previously determined as end point is
displayed in the main menu Navigation.
Arranging a new tour in tour mode
– In the main menu Navigation, press on the function key and
then on to change to the Tour mode.
– Press on the function key and then on to arrange a
new tour.
– Press on the function key in the menu Tour plan: New Tour behind
the display of the starting point or of an indicated destination.
– Press on in the pop-up window.
– Select a destination as described ⇒ page 42.
– If you have confirmed the first destination, the menu will again Tour
plan: New tour will be opened / has been opened. Press the function
key next to the destination behind which a further destination
should be inserted.
– Press on in the pop-up window and choose another
destination.
Extras
Enter intermediate destination
OK
Start
Extras Edit tour
Memory
Extras
Leave tour mode
Leave
Extras
Tour mode
Extras New tour
Destination entry
Destination entry
s2u4.6.book Page 49 Wednesday, August 13, 2008 7:57 AM
To Next Page
Loading...
Need help?
General
