Selector key NAV (Navigation) 53
– Give a short and clear name to the waypoint tour. Confirm the
displayed name by pressing .
– Select an acceptance mode by pressing the respective key.
– Press the function key to allow the system to automatically
set the waypoints (recommended) during the display.
– Press the function key if you wish to set all waypoints yourself
during the display.
– After starting the display, the number of used and still available
waypoints as well as the set display mode will be indicated in the
menu Waypoint navigation.
– Press the selector key to change into the map display. Repeated
pressing of the selector key will open and close the additional
window ⇒ page 52, fig. 21.
– Press on the selector key to switch back into the main menu
Waypoint navigation.
– Press the function key to set the
waypoints manually. When in the map display you can find this func-
tion key in the pop-up window for the function key
⇒ page 52, fig. 21 ⇒ page 53, “Function key in the map display”.
Function key in the map display
The waypoints used up to now for the tour and those still available are indicated in
the function key .
Pressing the function key ⇒ page 52, fig. 21 – will open a pop-up window
for controlling the display.
– ends the recording: the last set waypoint becomes the endpoint of the
waypoint tour.
– switches on and off the functions indicating that the
waypoints are set automatically via the sensors in the vehicle when changing the
direction. A tick in the checkbox indicates that the function is switched on.
– sets a manual waypoint at the current driving
position.
Driving a stored waypoint tour
Before you start driving a waypoint tour, you must be in the vicinity of the
desired starting point of this waypoint tour.
Select a waypoint tour
– Press the function key in the menu Waypoint navigation.
– Press on the function key in the pop-up window.
– Choose a waypoint tour in the list by pressing on the respective tour.
Driving a waypoint tour
– Press the function key in the menu Waypoint navigation. The
menu Starting from which waypoint will open. Starting and finishing
points of the waypoint tour are displayed at the top.
– Press the function key in the menu to drive the
selected tour in the opposite direction.
Stopping the route guidance
– Press the third function key at the bottom of the map display for infor-
mation about the distance to the closest waypoint and
in the pop-up window.
– Alternatively, press the selector key and then press the function
key .
When driving
Follow the information regarding turns as far as possible. Once you have come as
close as 50 meters to a waypoint, the drive recommendation will appear for the
next waypoint.
OK
Automatic
Manual
MAP
MAP
NAV
Store current position as waypoint
Record
Record
Record
Record
Stop
Automatic recording
Add current position as waypoint
Memory
Load tour
Start
Reverse waypoint tour
Stop route guidance
NAV
Stop
s2u4.6.book Page 53 Wednesday, August 13, 2008 7:57 AM
To Next Page
Loading...
Need help?
General
