EasyManua.ls Logo

Skoda Rapid Spaceback - Jump-Starting

Skoda Rapid Spaceback
184 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
If the tyre pressure is 1.3 bar or more
Set the tyre pressure back to the correct value » page 136.
Continue driving carefully to the nearest specialist garage at a maximum
speed of 80 km/h (50 mph).
WARNING
A tyre filled with sealant has the same driving characteristics as a standard
tyre. The following guidelines must be observed.
Do not drive faster than 80 km/h (50 mph).
Avoid accelerating at full throttle, sharp braking and fast cornering.
Jump-starting
Introduction
This chapter contains information on the following subjects:
Jump-starting using the battery from another vehicle
147
WARNING
The following instructions must be followed at all times when working on
the engine compartment » page 128.
When handling the vehicle battery, the following warnings must be ob-
served » page 133.
A discharged vehicle battery may already freeze at temperatures just be-
low 0 °C. If the battery is frozen, do not carry out a jump start with the bat-
tery of another vehicle – risk of explosion and injury!
Never jump-start vehicle batteries with an electrolyte level that is too low
– risk of explosion and caustic burns.
Jump-starting using the battery from another vehicle
Fig. 171 Jump-starting:
- discharged battery
- power-supplying bat-
tery / ground point of the engine for the START-STOP system
Fig. 172 Earth point and positive terminal on vehicles with the vehicle
battery in the luggage compartment
Read and observe on page 147 first.
If, because of a discharged battery, it is not possible to start the engine, the
battery of another vehicle can be used to start the engine. To do this, jump-
start cables are required which have a sufficiently large cross-section and in-
sulated terminal clamps.
The rated voltage of the two batteries must be 12 V. The capacity (Ah) of the
power-supplying battery must not be significantly lower than the capacity of
the discharged battery.
The jump-start cables must be attached in the following sequence.
Attach clamp
1
to the positive terminal of the discharged battery.
Attach clamp
2
to the positive terminal of the power-supplying battery.
147
Emergency equipment and self-help

Table of Contents

Related product manuals