Towing device and trailer
Hitch
Introduction
This chapter contains information on the following subjects:
Description 111
Adjusting the ready position 112
Check the setting of the standby position 112
Assembling the tow bar – Step 1 113
Assembling the tow bar – Step 2 113
Check proper fitting 114
Removing the tow bar – Step 1 114
Removing the tow bar – Step 2 114
Vertical load with mounted accessories 115
The maximum trailer nose weight when towing a trailer is 50 kg. Other infor-
mation (e.g. on the nameplate of the trailer device) provide only about the test
values of the device information.
WARNING
■
Check that the tow bar is seated correctly and is secured in the mounting
recess before the start of every journey.
■
When the ball rod is not used and properly secured in the receiving shaft,
this could be damaged or incomplete and must not be used - risk of acci-
dent.
■
Do not modify or adapt the towing device in any way.
■
Keep the mounting recess of the towing equipment clean at all times.
Such dirt prevents the ball head from being attached securely.
Description
Fig. 135 Carrier for the towing device / tow bar
Read and observe
on page 111 first.
The ball rod is detachable and is located in the stowage compartment for the
spare / emergency wheel.
Support for the towing device and tow bar » Fig. 135
Cap
Mounting recess
Protective cap
Locking ball
Centering
Hand wheel
Key
Lock cap
Red marking on the hand wheel
Tow bar
Green marking on the hand wheel
White marking on tow bar
Note
If you lose the key, please get in touch with a specialist garage.
1
2
3
4
5
6
7
8
9
10
11
12
111
Towing device and trailer