SKS-Kinkel Elektronik GmbH
Indoor station HT4600, Receiver, 2-wire
EN
Support Hotline: +49 (0) 2661 98088-112
Support E-Mail: support@sks-kinkel.de
Version No. 3.0
Document No. 97005003
34
Step Description
3 Keep hold of the programming button at the back of the device for ve seconds
until you hear a signal tone.
4 After this signal tone you will hear another short tone signalling that the programming of the
rst call address in the 1st storage space has been successful.
5 Change the DIP switch to the internal call address (= 2nd call address) which responds to
internal calls sent to this indoor station.
6 Keep hold of the programming button at the back of the device for ve seconds
until you hear a signal tone.
7 After this signal tone you will hear two more short tones when programming the second call
address, three for the third and four for the forth address programmed, so that you know
exactly which call address has been saved in which position (1 to 4) in your storage space.
8 To program further call addresses repeat steps 5 to 7. If you try to program more than four
call addresses this will be refused and signalled by a respective tone.
Attention
We do highly recommend to change the DIP switch back to the indoor station’s main
call address (i. e. the rst address programmed), so that it can easily be recognized
which bell button belongs to which indoor station in case of a breakdown.
A maximum of four call addresses can be programmed into an indoor station. In case call
addresses need to be changed all addresses that have been programmed into the indoor
station have to be deleted.
8.4.2 Deleting all internal call addresses the indoor station responds to from the call address
storage space
Single call addresses can not be deleted, all call addresses are always deleted at once. To
do so keep hold of the programming key for 25 seconds. Deleting is nished, when you hear
a three-second signal tone.
Attention
After deleting all programmed call addresses only the call address set at the DIP switch is
eective
To Next Page
Loading...
Need help?
General
