35
Support Hotline: +49 (0) 2661 98088-112
Support E-Mail: support@sks-kinkel.de
Version No. 3.0
Document No. 97005003
SKS-Kinkel Elektronik GmbH
Indoor station HT4600, Receiver, 2-wire
EN
8.4.3 Internal call addresses that are called from the indoor station
To be able to call other indoor stations in the same system (internal or group call, only possible with the 10-key
version of the HT4600) their internal call addresses have to be programmed into one of the six additional keys. To
do so follow these steps:
Step Image Description
1
B2
Set the internal call address of the indoor station, the indoor station is
supposed to call when key 1 is pushed.
2
+
Keep hold of the programming button on the back of the device and also
keep hold of key 1 within two seconds. Hold both keys for 5 seconds
until a signal tone is heard indicating that the programming has been
successful.
In the following if the receiver is picked up and key 1 is pushed, the re-
spective indoor station will be called.
3
B3
Set the internal call address of the indoor station, the indoor station is
supposed to call when key 2 is pushed.
4
+
Keep hold of the programming button on the back of the device and also
keep hold of key 2 within two seconds. Hold both keys for 5 seconds
until a signal tone is heard indicating that the programming has been
successful.
In the following if the receiver is picked up and key 2 is pushed, the re-
spective indoor station will be called.
. . . . . . . . .
8
B7
Set the internal call address of the indoor station, the indoor station is
supposed to call when key 6 is pushed.
9
+
Keep hold of the programming button on the back of the device and also
keep hold of key 5 within two seconds. Hold both keys for 5 seconds
until a signal tone is heard indicating that the programming has been
successful.
In the following if the receiver is picked up and key 6 is pushed, the re-
spective indoor station will be called.
Attention
If an internal call address is assigned to a key that has been assigned to a dierent
address before, the original programming will be deleted.
To Next Page
Loading...
Need help?
General
