8
Skydio Enterprise Controller - Operator Manual © 2021 Skydio, Inc. All rights reserved.
Getting Started
Charging Enterprise Controller
Enterprise Controller Charge Levels
When the controller is powered on or charging, the lights on the front of the controller will indicate the current state
of charge. When the controller is powered o, you can view the state of charge by pressing the power button.
NOTE: The Skydio Enterprise Controller supports charging while in use, including while flying.
Step 1 - Connect the controller using the USB-C cable and the 65 W power adapter
• or an o-the-shelf 18 W (or above) power adapter
Step 2 - Plug the power adapter into a 100-240 V power source
• flashing lights indicate charging
• the controller will power on and display the charge levels
• lights will remain solid blue for 1 minute and Skydio will power o indicating that the charging is complete
WARNING: Do not fly when the Skydio Enterprise Controller battery is low. If the Controller reaches low battery level
while in flight, pilot the drone to a safe location and land immediately.
To Next Page
Loading...