Section 4 Tables
Table 4.7 Operator’s Checklist
Function Tests
Test Drive Cutout Limit Switch
260AE_CE
Wear Pads
Optional Equipment/Attachments
Outdoor Option Flashing Light & Limit Switch (If
equipped)
Test Lowering Only Alarm
Optional Equipment/Attachments
Test All Motion Alarm (If equipped)
Test Outdoor Option Flashing Light (If equipped)
Motor Controller
Chains
Flashing Lights (If equipped)
Limit Switches
Mast Assembly
Test Flashing Lights (If equipped)
Hydraulic Pump and Motor
Hydraulic Oil
Steer Cylinder Assembly
Test Horn
Test Platform Raising/Lowering
Test Elevated Drive Speed
Main Manifolds
Test Pothole Sensor
Test SteeringPlatform Control Console
Test Driving
Manuals
Hydraulic/Electrical Compartment
Test Enable Trigger Switch
Fall Protection Anchorage(s) Test Lift/Off/Drive Switch Off Position
Battery Charger Test Platform Maintenance Limit Switch
Pothole Protection Device
Wheel/Tire Assembly Test Platform Emergency Stop
Base
Test Off/Platform/Base Switch
Main Power Disconnect Switch Test Lower/Neutral/Raise Switch
Base Control Switches Test Emergency Lowering
Limit Switches Test Base Emergency Stop Light
Visual and Daily Maintenance Inspections
Test Main Power Disconnect Switch
As each item is inspected, check the appropriate box.
Pipe Rack (If equipped)
Serial Number:
Model:
Operator's Name (Printed):
Date:
Time: Operator's Signature:
Each item shall be inspected using the appropriate section of the Skyjack operating manual.
Note:
Make a copy of this page or visit the Skyjack web site:
www.skyjack.com for a printable copy.
Vertical Mast
Page 55
TM