Skyjack SJ20 Operation Manual

17
SJ20 236504ACA
Safety instructions Section 2 – General Safety Precautions
DO NOT drive elevated near
depressions or holes of any
type, loading docks, debris,
drop-offs or surfaces that may
affect the stability of the MEWP.
IF OPERATION IN AREAS
WITH HOLES OR DROP-OFFS
IS ABSOLUTELY NECESSARY,
elevated driving shall not be
allowed. Position the MEWP
horizontally only with the
platform fully-lowered. After
ensuring that all 4 wheels have
contact with a firm, level
surface, the platform can be
raised. After elevation, the drive
function must not be activated.
DO NOT ascend or descend grades greater
than the maximum inclines listed in Section 7.3
. Ascending or descending slopes must only be
done when fully lowered.
DO NOT operate a MEWP that
has ladders, scaffolding, or
other devices on it to increase
the platform size or work height.
DO NOT exceed the maximum
side force on the platform
capacity label when elevated
(refer to Section 7.5).
DO NOT use the MEWP as a
crane.
DO NOT sit, stand, or climb on
the guardrails.
DO NOT climb on the base or
the mast.
DO NOT collide or crush.
Be aware of obstructions,
personnel, or other possible
hazards around the MEWP
when elevating, lowering, or
driving. Keep all body parts
inside the platform when
elevating or driving. Be aware
of blind spots when operating
the MEWP.
DO NOT elevate the platform
when the MEWP is on a truck,
forklift, or other device or
vehicle.
DO NOT use the MEWP when
the wheels or tires are damaged
(refer to section Section 4.2-6).
Make sure the wheel nuts and
cotter pins are in place.

Skyjack SJ20 Specifications

General

Brand	Skyjack
Model	SJ20
Category	Lifting Systems
Language	English