54
Section 5 – Operation Raise and lower with the SGLE platform control console (optional equipment)
5.8 Raise and lower with
the SGLE platform
control console (optional
equipment)
1. Energize the platform control console (refer to
Section 5.3).
2. Move the lift/off/drive switch to the lift position.
WARNING
Look for overhead obstructions or other possible
hazards around the MEWP when you raise the
platform. Do not lower the platform unless the area
below is clear of personnel and obstructions. If
you do not obey, there is a risk of death or serious
injury.
3. Push and hold the SGLE push-button and
squeeze the function-enable switch.
4. Push the controller handle until you are at the
necessary height.
5. Squeeze the function-enable switch.
6. Pull the controller handle to lower the platform.
NOTE
The SGLE does not have an effect on these functions:
lower, drive, steer, or emergency-lowering.
7. Release the controller handle until it goes
back to the center position to stop. Release the
function-enable switch.
5.9 MEWP shutdown
WARNING
Look for overhead obstructions or other possible
hazards around the MEWP when you raise the
platform. Do not lower the platform unless the area
below is clear of personnel and obstructions. If
you do not obey, there is a risk of death or serious
injury.
1. Select a reasonably well-protected location to
park the MEWP. This location must have a firm,
level surface, clear of obstructions, and traffic.
2. Fully lower the platform.
3. Push the emergency-stop button.
WARNING
Fall Hazard. Use the three points of contact
principle when you use the MEWP to enter or exit
the platform. If you do not obey, there is a risk of
death or serious injury.
4. Exit the platform.
5. Turn the off/platform/base key switch to the
off position on the base control console and
remove the key.
6. Push the emergency-stop button.
7. Turn the main power disconnect switch to the
off position.
To Next Page
Loading...
Need help?
General
