Skyjack SJ20 Operation Manual

30
SJ20236504ACA
Section 3 – Familiarization Optional equipment
With the Keypad:
NOTE
This touch-sensitive keypad beeps to identify a
correct input.
1. Enter the PIN code.
2. Press the green checkmark to confirm.
▪
Result: The green light identifies an approved
ID. Start the operation.
NOTE
If you push an incorrect button when you enter
the PIN code, push the Cancel button to start
again.
With the Smart ID Card:
1. Put the card in front of the reader.
2. A beep identifies that the reader read the
card.
▪
Result: The green light identifies an
approved ID. Start the operation.
IMPORTANT
If the set time of the access control unit expires,
enter the PIN code or tap the Smart ID card again.
If there is a failure of the access control activation,
speak to the MEWP owner.
IMPORTANT
The access control unit will not operate if these
power connections are not ON in the set time, or if
the operator disconnects them:
▪
The main power disconnect switch
▪
The emergency-stop button on the base
control console
▪
The off/platform/base key switch.
IMPORTANT
To start the access control unit, enter the PIN
code or tap the Smart ID card. These power
connections must be in the ON position in the set
time:
▪
The main power disconnect switch
▪
The emergency-stop button on the base
control console
▪
The off/platform/base key switch.
Function Tests
Do the function tests as specified in Section 4.3.
When you do the function tests, make sure that the
green light on the keypad is ON. This light confirms
that the access control unit is in operation. Do the
function tests for these power connections in the set
time:
▪
The main power disconnect switch
▪
The emergency-stop button on the base control
console
▪
The off/platform/base key switch.
FAMILIARIZATION

Skyjack SJ20 Specifications

General

Brand	Skyjack
Model	SJ20
Category	Lifting Systems
Language	English