57
Use the platform control console from the ground Section 6 – Additional Procedures
WARNING
Crush hazard. Make sure that there are no
personnel in the path you will travel. Tell personnel
around the path before you move the MEWP. Use
a second person to monitor the movement of
the MEWP. Make sure that person stays at a safe
distance. If you do not obey, there is a risk of death
or serious injury.
3. Stay behind or to the side of the MEWP.
4. Move the lift/off/drive switch to the drive
position.
5. Use as low a speed as practical to drive the
MEWP forward to the necessary location.
6. Push the emergency-stop button when the
MEWP is at the necessary location.
7. Turn the main power disconnect switch to the
off position.
WARNING
Fall hazard. Use the three points of contact
principle when you use the MEWP to enter or exit
the platform. If you do not obey, there is a risk of
death or serious injury.
8. Enter the platform and close the gate.
CAUTION
Make sure each lock-pin is correctly installed with
the detent ball of each lock-pin fully through the
hole.
9. Install the platform control console onto the
mounting bracket. Install the lock-pin in the
mounting bracket.
WARNING
Fall hazard. Use the three points of contact
principle when you use the MEWP to enter or exit
the platform. If you do not obey, there is a risk of
death or serious injury.
10. Exit the platform and close the gate.
To Next Page
Loading...
Need help?
General
