SKYJACK, Page 64 SJIII Compacts & Conventionals
February 2008
Section 2 - Operation Tables
General Maintenance
Before attempting any repair work, disconnect the battery by turning the main power disconnect switch
to off position. Preventive maintenance is the easiest and least expensive type of maintenance.
Table 2.7 Maintenance and Inspection Schedule
Frequency
Daily
3 months or
150 hours
Yearly
Frequency
Daily
3 months or
150 hours
Yearly
Lifting Mechanism
Labels A Maintenance Support A
Electrical A Scissor Assembly A
Limit Switches A Scissor Bumpers A
Hydraulic A Rollers A
Entrance Side Lift Cylinder(s) A
Main Power Disconnect Switch A
Base Control Switches A Test Main Power Disconnect Switch A
Free-wheeling Value Knob A Base Control Console
Brakes A Test Base Emergency Stop A
220V Outlet Receptacle A Test Enable Button (If Equipped) A
Ladder A Test Platform Raise/Lower Switch A
Battery Tray Side Test Emergency Lowering A
Pothole Protection Device A Test Free-wheeling A
Battery Tray A Platform Control Console
Battery Charger A Test Platform Emergency Stop A
Battery A Test Enable Trigger Switch A
Steer Cylinder Assembly A Test Steering A
Wheel/Tire Assembly A Test Driving A
Tie Rod (Conventionals) A Test Brakes A
Greasing Points A Test Platform Raising/Lowering A
Hydraulic/Electric Tray Side Test Lowering Warning A
Pothole Protection Device A Test Horn A
Hydraulic Tank A Test Pothole Sensor A
Hydraulic Oil A Test Speed Limit A
Hydraulic Pump and Motor A Test Tilt Sensor A
Electrical Panel A
60598AA-CE
Proportional and Main Manifolds A
Load/Tilt Sensor A
Emergency Lowering Access Rod (If Equipped) A
Platform Assembly A
Lanyard Attachment Anchors A
AC Outlet on Platform A
Platform Control Console A
Manuals A
Powered Extension Control Console (If Equipped) A
A - Perform Visual and Daily Maintenance Inspections & Functions Test. Refer to Section 2.8 and Section 2.9 of this manual.
B - Perform Scheduled Maintenance Inspection. Refer to Service & Maintenance manual.
* - Maintenance must be performed only by trained and competent personnel who are familiar with mechanical procedures.
Visual and Daily Maintenance Inspections
Function Tests
B*
B*
B*