Fit L-shape servo brackets to JR DS8511
Aileron servo must be mounted with horns facing
up and must be furthest from control surface
Secure servo horn and centre servo with TX.
Secure extension wire. Use safety clips on joint.
Fit servo to wing.
Draw a line perpendicular to hinge line.
Mark off area for aileron horn. Use dremel tool to cut slot.
Glue horn in place.
Fit pushrod. Mark location for fearing and secure in
position.
Mask flap in position.
Check that slots for flap hinges line up. Pivot point must be
where leading and trailing edge meet. Cut slots if not happy.
Use 30 minute epoxy to glue flap hinges. Make sure all
pivot points line up in straight line.
After epoxy cured, remove masking tape and check operation of flap,
Remove bolt at pivot point of flap hinge. Do not remove all three together. (First complete
one fearing before moving to next one. This will make sure
flaps stay aligned.
Slide fairings over hinges. Note large fairing is centre
fairing.
When happy glue fairings in position. Check operation of
flap.
P-13
Assembly & Operation Manual
Photo 18
Photo 19
Photo 20
Photo 21
To Next Page
Loading...
