P-22
Assembly & Operation Manual
Take-Off
Do some taxi tests before your flight! Make sure you are familiar with all settings and
make sure the model track straight on the ground without rudder input.
Choose a fine day for the maiden flight. Select take off flap or flight mode 1 and open
throttle. Gently pull back on stick 15m down the runway. Raise the flaps and gear at
safe altitude. If the ailerons feel sluggish—select higher rate. Land and adjust to fit
your need.
Slow Flight
Most of the first flight should be utilized to get familiar with the slow speed flight charac-
teristics. Select the flaps to the takeoff position; there should be no pitch change. Ex-
tend the gear and select full landing flaps; adjust the power to maintain level flight and
a speed of about 80—90mph. Climb to a safe altitude and slow the model to the edge
of a stall to know where that edge is.
Landing
Fly a complete circuit before landing. Approach from the downwind side and lower the
LG. Fly a complete circuit getting use to the power required. On the next circuit lower
the flaps. Just before touch down—pull more elevator to flare model. Let the model roll
out and apply brakes.
Taxi back and do necessary adjustments to customize PC21.
We at Skymaster wish you many happy flights with your PC21! Add some landing
lights for more realism.
Blue skies!
Anton Lin and Skymaster Team!
To Previous Page
