BEFORE YOU FLY
P-21
Assembly & Operation Manual
It is assumed that the builder of this kit has acquired the basic skills and knowl-
edge necessary to make a safe and functional radio control installation into a
model. Therefore, these notes are intended only to assist that experience.
TRAVEL MAX SETTINGS:
1. Elevator 37 mm at T/E
2. Rudder 64 mm each way
3. Aileron 20 mm each way
4. Flap 38 mm see picture 12 page 11
Do not change location of CG unless you are experience and have some feel of
model before! CG = 175mm from leading edge
Dry weight will be between 40 and 45 lbs depending equipment.
100—120 psi for pneumatic system
Make use of battery management system. Double up on batteries and make sure
all wired can carry current needed to operate.
Do a complete range check before flight. Do this with turbine running. Follow manu-
facturers instructions.
Set the maximum speed to 160mph! The prototype were tested with Kingtech turbo
prop turbines. This will be more than enough power for unlimited vertical perform-
ance.
Set a timer . It can safe your model.
To Next Page
