Model: 3301P2
INSTALLATION AND OPERATION INSTRUCTIONS
IF YOU CANNOT READ OR UNDERSTAND THESE INSTALLATION INSTRUCTIONS
DO NOT ATTEMPT TO INSTALL OR OPERATE
INTRODUCTION
This remote control system was developed to provide a safe, reliable, and user-friendly remote control system for gas heating
appliances or other compatible appliances. The system can be operated manually from the transmitter.
Review COMMUNICATION SAFETY under TRANSMITTER section and THERMO SAFETY under REMOTE RECEIVER section.
These signal/temperature safety features shut down the fireplace system when a potentially unsafe condition exists.
The transmitter operates on (2) AAA 1.5V batteries that are included. Install the
batteries supplied with the unit into the battery compartment. It is recommended
that ALKALINE batteries always be used for this product. Be sure the batteries
are installed with the (+) and (-) ends facing the correct direction.
When you start up the remote, if a low battery signal appears or if they LCD
screen does not illuminate, check battery position and if the batteries are fully
charged.
1. MODE - Switches the appliance on/thermo/off.
2. UP and DOWN - Used to change the time, set temp, and programming functions.
3. SET - Used in different functions to confirm settings.
4. PROG - Turns off and on program function.
LCD – LIQUID CRYSTAL DISPLAY
1. LOW BATTERY - Battery power is low. Replace Batteries in 2 - 4 weeks.
2. MODE - Indicates operation mode of system.
3. FLAME- Indicates the burner/valve in operation.
4. ROOM - Indicates CURRENT room temperature.
5. SET- Indicates desired SET room temperature in Thermo operation.
6. FAHRENHEIT/CELSIUS – Indicates degrees Fahrenheit or Celsius.
7. DAY OF WEEK – Indicates current day of week, or program segment when editing
program settings.
8. PROGRAM ON/OFF – Indicates when Program 1 (P1) is on or off, and indicates
when Program 2 (P2) is on or off.
9. TIME and PROGRAM TIME – Indicates current time or program time setting when
editing program settings.