5 Repeat step 5 for each of the HUI control sections on this screen,
selecting vcontrol 2 and vcontrol 3 in the Receive from and Send to
sections.
6 Close the window by hitting, “Ok.”
These settings will save in Pro Tools for future sessions.
Launching RAVEN MTi Software
After all connections are made in the RAVEN MTi hardware and in Pro Tools.
You will be ready to launch the RAVEN MTi software.
The following sequence must be followed in order to achieve proper connection
from RAVEN MTi to Pro Tools.
1 Ney-Fi
2 Pro Tools
3 RAVEN MTi
We recommend keeping these three applications in your dock at all times. Also
note that we recommend right-clicking the Ney-Fi app and having it
automatically launch with the Finder.
Once RAVEN MTi is launched it will sync with your current session, and make all
connections automatically. The mouse will not function in the RAVEN Mixer
window, however, touch will control it from this point forward.
Review of Touch Calibration
IMPORTANT
Calibration is the most important process for accurate use of the screen. Failure
to calibrate properly will result in poor touch performance.
DO NOT RUN ANY APPLICATIONS UNTIL CALIBRATION IS COMPLETED
3. Run the RAVEN MTi installer and download the drivers onto your hard
drive.
4. Restart your computer for changes to take effect.
To calibrate RAVEN MTi use the following procedure:
To Next Page
Loading...
