15
5693
21 2023
-
SE60/185 s2
MC_0258
Gear Leg & Motor Bracket Installation
! Please refer to the graphic for special considerations relating to your model !
1. Mark the tunnel centreline and the boat’s centreline. (NB: Install the gear leg and propeller as shown for the thrust direction to correspond with
the control panel.)
2. Use the gasket or template (recommended) to mark the hole centres and double-check the measurements. One hole MUST be placed using
the boat centreline as shown above. (NB: All holes must be in-line with the tunnels’ centreline for correct installation, clearance between the
propeller and the tunnel is minimal.)
3. Drill the main centre hole followed by the two screw-holes.
4. Smooth the surface of the tunnel. A rough surface will cause possible failure/ movement of the gear leg. The motor bracket must rest steadily on
the tunnel.
MC_0258
Gear Leg & Motor Bracket Installation
! Please refer to the graphic for special considerations relating to your model !
5. Place the gear leg (without the propeller) with the gasket on inside the tunnel.
6. Place the propeller on the gear leg (NB: Do not secure the propeller with securing parts) to ensure it is centred and rotates freely with the same
clearance from each blade to the tunnel wall.
7. Place top motor bracket and bolt plate to measure the drive shaft has come through the motor bracket at the correct height. Remove the gear leg
and propeller for nal installation.
MG_0616
Gasket
Gear leg
Test the propeller turns without
obstruction with tunnel wall
Motor
bracket
Bolt plate
7
Gasket
Bolt plate
Bracket
BOW
5
6
BOW
Bolt plate
MIN
MAX
Measure the drive shaft has come through the motor
bracket at the correct height with the template supplied.
The template must sit on the
bracket surface with the bolt
plate within the measurement
cutout
MIN
MAX
To Next Page
Loading...
