SMA Home Storage HS-BM-3.28-10 - Safety; Intended Use; Important Safety Information

2 Safety
SMA Solar Technology AG
Operating Manual 9HS-BM-3.28-10-BE-en-10
2 Safety
2.1 Intended Use
SMA Home Storage is a system from one or several battery modules and can be used in the SMA Home Storage
Solution for home applications, including for increasing self-consumption.
The communication interface of the inverter used must be compatible with the product. The entire voltage range must
be completely within the permissible input voltage range of the inverter. The maximum permissible DC input voltage of
the product must not be exceeded.
No additional loads or components in the DC connection may be connected between the battery and inverter.
The product is suitable for indoor and outdoor use.
The product must only be used as stationary equipment.
All components must remain within their permitted operating ranges and their installation requirements at all times.
The product is not suitable for supplying life-sustaining medical devices. A power outage must not lead to personal
injury.
The product must only be used in countries for which it is approved or released by SMA Solar Technology AG and the
grid operator.
Use SMA products only in accordance with the information provided in the enclosed documentation and with the
locally applicable laws, regulations, standards and directives. Any other application may cause personal injury or
property damage.
Alterations to the SMA products, e.g., changes or modifications, are only permitted with the express written permission
of SMA Solar Technology AG. Unauthorized alterations will void guarantee and warranty claims and in most cases
terminate the operating license. SMA Solar Technology AG shall not be held liable for any damage caused by such
changes.
Any use of the product other than that described in the Intended Use section does not qualify as the intended use
The enclosed documentation is an integral part of this product. Keep the documentation in a convenient, dry place for
future reference and observe all instructions contained therein.
This document does not replace any regional, state, provincial, federal or national laws, regulations or standards that
apply to the installation, electrical safety and use of the product. SMA Solar Technology AG assumes no responsibility
for the compliance or non-compliance with such laws or codes in connection with the installation of the product.
The type label must remain permanently attached to the product.
2.2 Important Safety Information
Keep the manual for future reference.
This section contains safety information that must be observed at all times when working.
The product has been designed and tested in accordance with international safety requirements. As with all electrical
or electronical devices, some residual risks remain despite careful construction. To prevent personal injury and property
damage and to ensure long-term operation of the product, read this section carefully and observe all safety
information at all times.