SMA PPM-10 - Mounting Procedure

5 Mounting
SMA Solar Technology AG
Installation ManualPPM-10-IA-en-1622
5.2 Mounting the product
CAUTION
Risk of injury due to weight of product
Injuries may result if the product is lifted incorrectly or dropped while being transported or mounted.
• Transport and lift the product carefully. Take the weight of the product into account.
• Always have two persons mount and disassemble the product.
• Wear suitable personal protective equipment for all work on the product.
Additionally required mounting material (not included in the scope of delivery):
☐ 4 screws, washers and fastening material suitable for the support surface
Requirements for anchoring points:
☐ Weight force at each of the 4 anchoring points (screw and fastening material): at least 75kg (165lb)
Procedure:
1. Attach the wall mounting bracket to the enclosure using fastening
material, torque: 13 Nm (115 in-lb)).
2. Mark the position of the 4 drill holes and drill the holes. Use the recesses for the upper wall mounting brackets
and the holes for the lower wall mounting brackets.
3. If necessary, provide the 4 drill holes with suitable screw anchors.
4. Turn suitable screws with washers into the upper 2 drill holes. Turn the screws far enough to be able to hang the
product on them.
5. Hang the product onto both upper screws.