SMA PPM-10 - Twice Executed High-Precision Current and Voltage Measurement; High-Precision Current and Voltage Measurement and Synchronization

6 Electrical Connection
SMA Solar Technology AG
Installation ManualPPM-10-IA-en-1630
6.1.6 Twice executed high-precision current and voltage measurement
A
B C
Figure 16: Setup of the twice executed current and voltage measurement (variant: Hybrid Controller XL 2xGMP)
Position Designation Description
A Processor assembly of the pro-
grammable logic controller
K100
Without external terminal
B
Digital I/O module K101 The terminal block X702 is intended for the connection of the inputs
and outputs.
C Power analyzer with measuring
modules K103 and K104
Current and voltage measurement
The terminal block X700 is intended for the two current measure-
ments.
The terminal block X200 is intended for the two voltage measure-
ments.
6.1.7 High-Precision Current and Voltage Measurement and Synchronization
A
B C D
Figure 17: Setup of the high-precision current and voltage measurement and the synchronization (variant: Hybrid Controller XL Synch)
Position Designation Description
A Processor assembly of the pro-
grammable logic controller
K100
Without external terminal
B
Digital I/O module K101 The terminal block X702 is intended for the connection of the inputs
and outputs.