Mounting SMA America, LLC
32 SB50US-80US-eng-IUS112633 Installation Guide
5.3.3 Mounting the SMA DC Disconnect
Dimensions for the DC Disconnect
Attach the SMA DC Disconnect to the two lower holes of the wall mounting bracket, using the two
screws and washers provided.
1. Insert screws with washers through the holes of the
fastening straps of the DC Disconnect. The teeth of
the washers must lie on the fastening straps of the
DC Disconnect.
2. Put the SMA DC Disconnect onto the wall mounting
bracket.
3. Tighten the screws with a tightening torque of
44 in‑lbs. (5 Nm).
To Next Page
Loading...
