7 Periodic Actions
SMA Solar Technology AG
Maintenance ManualSCCPXT-E7-WA-en-3766
7.3.2 Saving Parameter Changes
Requirement:
☐ You must be logged in on the user interface.
Procedure:
1. Change the respective parameter via the field Value.
2. To adopt this value for all devices of the same type and with the same firmware version, activate the box Save
for all devices of this device type.
3. Select the button [Save].
☑ The communication unit adjusts the required value on the device(s).
4. Select the button [OK].
7.4 User Interface
7.4.1 Logging Into the User Interface
Default Network Settings for the Service Interface
IP address: 192.168.100.2
Subnet mask: 255.255.255.0
Password for the user groups "installer" and "user": sma
Identical passwords for the user groups
If your "user" password is the same as your "installer" password, you will automatically be logged in as an
installer.
Requirement:
☐ JavaScript must be enabled in your web browser (e.g. Internet Explorer).
Procedure:
1. Connect the laptop to the service interface of the inverter.
2. Start your web browser.
3. Enter the IP address of the communication unit in the address bar and press the enter key.
☑ The user interface opens.
4. To change the language, select the desired language in the field Language.
5. For registration select the user level in the field User.
6. Enter the password in the field Password.
7. Select the button [Login].
7.4.2 Logging Out of the User Interface
Always log out from the user interface when you have finished your work. If you only close the web browser, you will
not be logged out. If the user interface is left idle for 15minutes, you will be logged out automatically.
Procedure:
• Select the button [Logout].
To Next Page
Loading...
