SMA SUNNY ISLAND 6048-US - Stopping the Sunny Island (Standby); Switching off; Disconnecting the Device from Voltage Sources

9 Switching On and Off SMA Solar Technology America LLC
76 SI4548-6048-US-BE-en-21 Operating Manual
4. Press and hold <ENTER>.
☑ Process bar is shown in the display.
☑ On a slave, the notification displayed here is
shown until the master is started.
5. Press <ENTER> on the master.
☑ An acoustic signal sounds. The Sunny Island is in operation and the green LED is glowing.
9.2 Stopping the Sunny Island (Standby)
Proceed as follows to stop the Sunny Island:
1. Press <ENTER> or <ESC> to stop the Sunny Island.
☑ The notification shown here is displayed.
2. Press and hold <ENTER>.
☑ The remaining time is displayed as a bar.
☑ The Sunny Island is stopped. The notification shown
here is displayed.
9.3 Switching Off
To switch off the Sunny Island, proceed as follows:
1. Stop the Sunny Island (see Section9.2 "Stopping the Sunny Island (Standby)", page76).
2. Switch the DC circuit breaker of the Sunny Island to "OFF".
☑ The Sunny Island is switched off.
9.4 Disconnecting the Device from Voltage Sources
1. Switch off the Sunny Island (see Section9.3 "Switching Off", page76).
2. Disconnect the Sunny Island from the battery.
Standby
Even in standby mode the Sunny Island still requires approx. 4 W of power from the battery.
"Switching sequence"
Only with the sequence shown here can you ensure that all internal meter positions/values are
saved.